Opti-ups DS20KBT Manuel d'utilisateur

User Guide Durable Series 6KVA~20KVA IEMC Statements CISPR 22 NOTICE: Pursuant to CISPR 22 rules, this product has been tested

16 5.4 Default settings at the factory On the LCD display you will find several of the UPS parameters to select. Default settings are as follows: Set

18 USB port (option) Connecting the UPS to your computer is accomplished through the USB port on the back of your computer. USB compliant hardware an

20 7.2 Button operation Please note the five operating buttons on the front panel: 1. “ON/OFF” button: (a) Push “ON/OFF” button (at least 1 seconds

22 Status of the UPS, measurements and alarms are all indicated on the LCD screen. RM- LCD PANEL TOWER- LCD PAN

24 Settings LCD display Explanation Selection Factory default Output Volt.Setting O/P V Setting Select Nominal Voltage 208/220/230/240 V 230V Inpu

26 7.4 Interpreting UPS messages Troubleshooting procedures described here give simple instructions in determining UPS malfunctions. Start the troubl

28 8. Maintenance With a minimal amount of maintenance, you can expect the UPS to application, otherwise consider changing the batteries. have a long

30 HV Model OUTPUT POWER 6KVA RM 6KVA 8KVA 10KVA 12KVA 15/20KVAConnection Input Hardwired Hardwired Hardwired Hardwired Hardwired HardwiredConnec

32 11. DS6000B-RM (3U+3U) Mechanical A. DS6000B-RM RACK-MOUNT(3U+3U) DESIGN: (1) BASIC COMPONENT: INCLUDING 3U-UPS & 3U-BATT. CABINET FRONT VIE

34 (4) FEATURE of REMOTE CONTROL FUNCTION: a. Remove the original right side panel and take apart the control panel unit. Then assemble the blank r

II CONTENTS 1. Introduction...2 2. System description...

36 (1) 19” Rack installation: Mount the 3U rack-mount in a 19-inch EIA 310 C standard rack. (2) 23” Rack installation: Change the position of

38 (5) Installation with rear Bracket: We can use bracket to support the rear side of UPS or battery cabinet.

2 The instructions contained within this safety manual are deemed important and should be closely followed at all times during installation and follo

4 Fig.1. Block diagram Efficiency Optimizer function The Efficiency Optimizer function is a new feature for the UPS adding cost effectivenes

6 3. Safety information Information presented here is vital to all personnel and please also read the UPS safety manual. Storage and Transportation P

8 5.2 Rear panel views 5K~6KVA Rear panel (STANDARD) 9 5K~6KVA Rear panel (With ISO)

10 8K~10KVA Rear panel (STANDARD) 118K~10KVA Rear panel (With ISO)

12 12 KVA Rear panel (STANDARD & With ISO) 13 15/20 KVA Rear panel (STANDARD & With ISO)

14 5.3 Connection to mains and loads (6000 - 20000 VA) Only qualified specialists or technicians who conform to applicable safety standards may carry